 In order to mount the seat,...  In order to mount the seat, you must have a seat pan already made, preferably constructed from steel. The seat tab nose mount should also be centered on the frame, then welded into place. |  Moving to the bottom of the...  Moving to the bottom of the frame, he unbolted the tranny mount and tack welded the compressor bracket to the bottom side of the plate. |  Cox loosely bolted the compressor...  Cox loosely bolted the compressor to the plate and made sure the mounting bolts for the trans did not interfere with the compressor. |
 He bolted the trans plate...  He bolted the trans plate and compressor assembly to the frame. |  He snugged down the bolts...  He snugged down the bolts for the compressor. If everything fits without interference, unbolt the trans mount and the compressor, and permanently weld the compressor bracket to the trans mount and bolt everything back together. |  In an area within arms reach...  In an area within arms reach while in the seat, Cox mounted the toggle switch so adjustments could be made while riding. |
 He ran the wiring to the switch...  He ran the wiring to the switch following the guidelines in the included instruction sheet. |  The air springs were secured...  The air springs were secured to the bracket. |  He installed the 90-degree...  He installed the 90-degree air-line fittings to the bottom of the air-springs. |