74 Clutch Upgrade
|
28. The outer spring plate should run parallel to the pressure plate. The easiest way is to measure the distance between the two with a scale measured at each long stud. There will be a difference between the measurement with the aluminum plate and the stock steel plate. Our measurements indicated it to be about 11/16 inch, as shown. We then adjusted the pushrod screw in until it touched the pushrod, backed out a quarter turn and locked down the locknut. The last step was to adjust the clutch cable keeping in mind that there should be at least 1/8 inch of free play at the lever. View Related Article
|
|
|
|