Using a couple of hole saws we made a 2-inch hole for the Hummer Tank's donated gas filler and a 3-inch hole for its switch housing. Once the holes were properly sized with a die grinder, we slid each one in and tack welded them.
We then decided that the tank was looking a bit too tall so we cut 2 inches out of the bottom of the shell. For the tunnel of the tank, like this tank's Friscoed counterpart, we employed a piece of 1 1/2-inch DOM tubing that was cut in half. We also carefully cut out the tank bottoms with a similar tracing style as the other tank, which garnered great results. With the tank tacked into place and to our liking, we finish welded it.
Check out the next issue of STREET CHOPPER when we lay some paint on these two beauties!